Boss Audio Systems GT-10B - Manual (Page 53)

53
Chapter 4 Playing Sounds
Chapter
4
Parameters That Can Be Set in List View
The following describes the parameters that can be set when you switch to List View in the ASSIGN screen.
Pressing [DISPLAY MODE] toggles the display between Knob View and List View.
* The screen that’s shown uses ASSIGN No. 1 as an example.
For more information about each parameter, refer to “ASSIGN 1–8” (p. 126).
Parameter Explanation
Target Use to select the parameter you want to control.
Min This sets the minimum value for the target’s controllable range.
Max This sets the maximum value for the target’s controllable range.
Parameter Explanation
Source This selects the controller assigned to the function.
Src Mode
Moment
The normal state is Off (minimum value), with the switch On (maximum
value) only while the footswitch is depressed.
Toggle
The setting is toggled On (maximum value) or Off (minimum value) with
each press of the footswitch.
ActRngLo This sets the minimum for the range in which the value of the setting can be changed.
ActRngHi This sets the maximum for the range in which the value of the setting can be changed.
GT-10B_e.book 53 ページ ２００８年２月２６日 火曜日 午後３時３０分