Boss Audio Systems GT-10B - Manual (Page 93)

93
Chapter 6 Using the GT-10B with External MIDI Devices Connected
Chapter
6
You can restore settings by importing data that has been saved on a MIDI sequencer or the like by a bulk dump. This data-
receiving operation is called a “bulk load.”
Receiving Data from an External MIDI Device (Bulk Load)
Making the Connections
When Receiving Data Saved on a MIDI Sequencer
Connect as shown below. Set the GT-10B’s Device ID to the same number that was used when the data was transmitted to the MIDI
sequencer (p. 85).
For instructions on operating the sequencer, refer to the owner’s manual for the sequencer you are using.
Receiving
1. Transmit the data from the external MIDI device.
• When data is being received, the message
“BULK DATA RECEIVING...” appears on the
display.
• Keep the power on while the bulk data is being
received.
• If the message “MIDI BUFFER FULL” appears,
check the connections and reduce the tempo of
the transmitting MIDI device.
BPM
PHRASE LOOP ON / OFF
MIDI IN
MIDI OUT
GT-10B_e.book 93 ページ ２００８年２月２６日 火曜日 午後３時３０分