Boss Audio Systems GT-10B - Manual (Page 124)

124
Chapter 8 Parameters Guide
Pedal Bend/PB
This lets you use the pedal to get a pitch bend effect.
Because of the need to analyze the pitch, chords (two or more sounds played
simultaneously) cannot be played.
Parameter/
Range Explanation
Custom
Setting available when Type is set to Custom.
Type
This selects the basic sound when the TYPE parameter is set to Cus-
tom.
CRY WAH
This models the sound of the CRY BABY wah
pedal popular in the ’70s.
VO WAH This models the sound of the VOX V846.
Bass WAH
This wah has been specially adapted for use in
the bass registers.
Inclusion of the low-frequency range in the
wah sound produces a robust wah effect, with
no dilution of the sound.
Q
-50–+50
Adjusts the amount of characteristic effect ap-
plied to the wah tone.
Range Low
-50–+50
Selects the tone produced when the pedal is
back.
RangeHigh
-50–+50
Selects the tone produced when the pedal is for-
ward.
Presence
-50–+50 Adjusts the tonal quality of the wah effect.
Parameter/
Range Explanation
Pitch Min (Pitch Minimum)
-24–+24
This sets the pitch at the point where the EXP
Pedal is fully lifted.
Pitch Max (Pitch Maximum)
-24–+24
This sets the pitch at the point where the EXP
Pedal is all the way down.
Pdl Pos. (Pedal Position)
0–100
Adjusts the pedal position for pedal bend.
This parameter is used after it’s been assigned to an
EXP Pedal or similar controller.
EffectLev (Effect Level)
0–100 Adjusts the volume of the pitch bend sound.
DirectLev (Direct Level)
0–100 Adjusts the volume of the direct sound.
MONO
GT-10B_e.book 124 ページ ２００８年２月２６日 火曜日 午後３時３０分