Boss Audio Systems GT-10B - Manual (Page 72)

72
Chapter 5 Making Global Settings
The GT-10B features a mode that is enabled when spatial effects (such as reverb and delay) are used, whereby the effects sound of
one patch continues playing even after you switch to the next patch. If the necessary following conditions regarding the effects
chain and effect parameter settings are met, you can then have the decay of reverb, delay, and similar effects continue on into the
next patch after you switch patches.
• Effects are in the same effects chain
• When the Delay Type parameter and Dly Time parameter are identical
• When switching other effects off or on, or when the parameter settings are identical
There still may be no reverberation in some cases, even after the above settings are made.
Keeping Effect Sounds Playing After Patches Are Switched
(Patch Change Mode)
1. The SYSTEM MENU screen appears.
2.
Select PLAY OPTION.
3. The PLAY OPTION screen appears.
4.
Move the cursor to Patch ChgMode.
5. Select the value of the Patch ChgMode parameter.
Value Explanation
Fast
Patches are changed normally. The unit switches to the subsequent patch without any carry-over of the decay
from the previous patch’s reverb or delay.
Smooth
The unit switches to the subsequent patch with the decay from the previous patch’s reverb or delay continued
after the switch is made.
To ensure smooth switching, the patches may be switched with a delay of one tempo beat.
SYSTEM
GT-10B_e.book 72 ページ ２００８年２月２６日 火曜日 午後３時３０分