Boss Audio Systems GT-10B - Manual (Page 141)

141
Chapter 8 Parameters Guide
Chapter
8
This selects the type of device connected to the OUTPUT jacks.
• To derive the maximum performance from the GT-10B, be sure to make
the correct setting for OUTPUT SELECT, the one that’s most suitable for
your setup.
• The OUTPUT SELECT function affects sounds from the OUTPUT jacks.
The output from the SUB OUTPUT jacks will always be equivalent to the
sound that is output when the LINE/PHONES setting is used.
• If the headphones are connected to the PHONES jack, the output from
OUTPUT jack and PHONES jack will be equivalent to the sound that is
output when the LINE/PHONES setting is used.
OUTPUT SELECT
Parameter/
Range Explanation
Mode
Patch
This uses the patch’s Output Select setting. You
can use a different output setting for each indi-
vidual patch.
System
This uses the system’s Output Select setting.
The same output setting is used for all patches.
Select
AMP WITH
TWEETER Use this setting when connecting to a tweeter-
equipped bass amp.
AMP NO
TWEETER
Use this setting when connecting to a bass amp
that has no tweeter. The high-frequency range
is adjusted.
LINE/PHONES
Use this setting when using headphones or
when recording with the GT-10B connected to
a multitrack recorder.
GT-10B_e.book 141 ページ ２００８年２月２６日 火曜日 午後３時３０分