Boss Audio Systems GT-10B - Manual (Page 86)

86
Chapter 6 Using the GT-10B with External MIDI Devices Connected
This setting determines whether or not Program Change messages are output when patches are switched on the GT-10B.
This sets the controller number when EXP Pedal operation data is output as Control Change messages.
This sets the controller number when EXP PEDAL SW operation data is output as Control Change messages.
This sets the controller number when operation data from the EXP PEDAL connected to the EXP PEDAL 2 jack is output as
Control Change messages.
Sending Program Change Messages
1. Follow the procedure in “Making the Settings for MIDI Functions” (p. 84) to move
the cursor to “PC Out.”
2. Set the desired
value.
Off
Program Change messages are not output, even
when patches are switched.
On the GT-10B, Bank Select messages are
output simultaneously with Program Change
messages. For more details, refer to p. 89.
On
Program Change messages are simultaneously out-
put when patches are switched.
Sending EXP Pedal Operations as Control Change Messages
1. Follow the procedure in “Making the Settings for MIDI Functions” (p. 84) to move
the cursor to “EXP1 Out.”
2. Set the desired
value. Off Control Change messages are not output.
CC#1–CC#31,
CC#64–CC#95 This sets the controller number when EXP Pedal op-
eration data is output as Control Change messages.
Sending EXP Pedal Sw Operations as Control Change Messages
1. Follow the procedure in “Making the Settings for MIDI Functions” (p. 84) to move
the cursor to “EXP Sw Out.”
2. Set the desired
value. Off Control Change messages are not output.
CC#1–CC#31,
CC#64–CC#95
This sets the controller number when EXP PEDAL
SW operation data is output as Control Change mes-
sages.
Sending External EXP Pedal Operations as Control Change Messages
1. Follow the procedure in “Making the Settings for MIDI Functions” (p. 84) to move
the cursor to “EXP2 Out.”
2. Set the desired
value. Off Control Change messages are not output.
CC#1–CC#31,
CC#64–CC#95
This sets the controller number when external EXP
Pedal operation data is output as Control Change
messages.
GT-10B_e.book 86 ページ ２００８年２月２６日 火曜日 午後３時３０分