Boss Audio Systems GT-10B - Manual (Page 103)

103
Chapter 8 Parameters Guide
Chapter
8
Type=CONCERT 810
Type=BASS 360
Type=T.E.
Type=SESSION
Type=GTR Clean, GTR Crunch
Type=GTR Drive, GTR Metal
Parameter/
Range Explanation
Mid Freq (Middle Frequency)
220Hz, 800Hz,
3.0kHz Specifies the center of the frequency range that
will be adjusted by the Mid Freq.
Bright
Turns the bright setting on/off.
Off Bright is not used.
On
Bright is switched on to create a lighter and
crisper tone.
Ultra Lo
-, 0, + This controls the character of the lower range.
Ultra Hi
Off, On
This controls the ultra high-frequency range ly-
ing beyond treble.
Parameter/
Range Explanation
Bright
Turns the bright setting on/off.
Off Bright is not used.
On
Bright is switched on to create a lighter and
crisper tone.
Parameter/
Range Explanation
Mid Freq (Middle Frequency)
220Hz, 800Hz,
3.0kHz Specifies the center of the frequency range that
will be adjusted by the Mid Freq.
Pre Shape
Off, 1, 2
This is a shape switch that adds a particular nu-
ance to the midrange.
Parameter/
Range Explanation
Mid Freq (Middle Frequency)
220Hz, 800Hz,
3.0kHz Specifies the center of the frequency range that
will be adjusted by the Mid Freq.
Enhancer
0–100
This controls the clarity and presence of the
sound.
Parameter/
Range Explanation
Presence
0–100 Adjusts the tone for the ultra high frequency range.
Bright
Turns the bright setting on/off.
Off Bright is not used.
On
Bright is switched on to create a lighter and crisper
tone.
Gain Sw
Low,
Middle,
High
Provides for selection from three levels of distor-
tion: Low, Middle, and High. Distortion will suc-
cessively increase for settings of Low, Middle and
High.
The sound of each Type is created on the basis that the
Gain is set to Middle. So, normally set it to Middle.
Solo Sw
Off, On
Solo Sw is switched on to create the tone to one suit-
able for solos.
SoloLevel
0–100 Adjusts the volume level when the Solo Sw is ON.
Parameter/
Range Explanation
Presence
0–100 Adjusts the tone for the ultra high frequency range.
Gain Sw
Low,
Middle,
High
Provides for selection from three levels of distor-
tion: Low, Middle, and High.
Distortion will successively increase for settings of
Low, Middle and High.
The sound of each Type is created on the basis that the
Gain is set to Middle. So, normally set it to Middle.
Solo Sw
Off, On
Solo Sw is switched on to create the tone to one suit-
able for solos.
SoloLevel
0–100 Adjusts the volume level when the Solo Sw is ON.
GT-10B_e.book 103 ページ ２００８年２月２６日 火曜日 午後３時３０分