Boss Audio Systems GT-10B - Manual (Page 91)

91
Chapter 6 Using the GT-10B with External MIDI Devices Connected
Chapter
6
With the GT-10B, you can use Exclusive messages to set another GT-10B to the same settings or to save effect sound settings to
MIDI sequencers and other such devices. This transmission of data is referred to as bulk dump.
Transmitting Data to an External MIDI Device (Bulk Dump)
Making the Connections
When Saving to a MIDI Sequencer When Transmitting Data to Another GT-10B
Connect as shown in the figure below, and put the sequencer in
the state where it is ready to receive Exclusive messages. Connect as shown in the figure below, and match the Device ID
for the transmitting and receiving devices (p. 85).
fig.08-140 fig.08-150
For instructions on operating the sequencer, refer to the owner’s manual
for the sequencer you are using.
BPM
PHRASE LOOP ON / OFF
MIDI OUT
MIDI IN
BPM
PHRASE LOOP ON / OFF
BPM
PHRASE LOOP ON / OFF
MIDI OUT
MIDI IN
GT-10B_e.book 91 ページ ２００８年２月２６日 火曜日 午後３時３０分