Boss Audio Systems GT-10B - Manual (Page 39)

39
Chapter 2 Creating Sounds (Patch Edit)
Chapter
2
GT-10B’s effector has two routes (EFFECT CHANNEL). You can use it by switching or mixing each route for application as
needed.
Using Two Different Type Effects (Channel Select)
1.
The MST/PDL FX screen appears.
2.
Select CH. SELECT.
3.
The CH. SELECT screen appears.
• Pressing [DISPLAY MODE] toggles the display
between Knob View and List View.
For information on the parameters, refer to
“CH.SELECT (Channel Select)” (p. 133).
• When you want to change the effect channel,
press [CHANNEL SELECT].
4. Select the Ch.Mode.
You can also select the Ch.Mode using P2 knob.
Value Explanation Value Explanation
Single
Only the channel se-
lected with Ch.Se-
lect or [CHANNEL
SELECT] is used.
Dynamic
SW
Channels A and B are
switched according to the
bass input volume level.
This produces dynamic ton-
al changes in response to the
picking dynamics.
Dual
Mix
The output of Chan-
nels A and B is
mixed.
Dynamic A
Channel A’s volume level is controlled. The volume in
Channel B is fixed.
Dual
L/R
Channel A is output
from the left and
Channel B is output
from the right.
Dynamic B
Channel B’s volume level is controlled. The volume in
Channel A is fixed.
Freq
Divide
The low-frequency
range is assigned to
Channel A, and the
high-frequency
range is assigned to
Channel B.
A
B
A
B
Detect
Input Level
A
B
A
B
L
R
A
B
Low-frequency
Range
High-frequency
Range
GT-10B_e.book 39 ページ ２００８年２月２６日 火曜日 午後３時３０分