Boss Audio Systems GT-10B - Manual (Page 81)

81
Chapter 5 Making Global Settings
Chapter
5
Although the GT-10B’s EXP Pedal has been set for optimum operation at the factory, extended use and the operating environment
can result in the pedal going out of adjustment.
If you encounter problems such as being unable to fully cut off the sound with the volume pedal or being unable to switch the
EXP PEDAL SW, you can use the following procedure to readjust the pedal.
Adjusting the EXP Pedal (Pedal Calibration)
1. The SYSTEM MENU screen appears.
2.
Select PDL CALIBRATION.
3.
The PEDAL CALIBRATION screen appears.
4. Depress the heel of the EXP Pedal.
5.
The message “OK” appears, and then the following screen is dis-
played.
If you press [CATEGORY/ENTER] without
pressing down on the heel of the EXP Pedal or
with an inappropriate EXP Pedal value (angle),
“Out of Range! Set again” appears in the display,
and you are prevented from proceeding to the next
step. Readjust the pedal position.
6. Depress the toe of the EXP Pedal.
7.
The message “OK” appears, and then the following screen is dis-
played.
If you press [CATEGORY/ENTER] without
pressing down on the toe of the EXP Pedal or with
an inappropriate EXP Pedal value (angle), “Out of
Range! Set again” appears in the display, and you
are prevented from proceeding to the next step.
Readjust the pedal position.
SYSTEM
GT-10B_e.book 81 ページ ２００８年２月２６日 火曜日 午後３時３０分