Boss Audio Systems GT-10B - Manual (Page 120)

120
Chapter 8 Parameters Guide
Pan
Parameter/
Range Explanation
Tap Time
0–100%
Adjusts the delay time of the left channel
delay. This setting adjusts the L channel
delay time relative to the R channel delay
time (considered as 100%).
Dual-S, Dual-P, Dual-L/R
Parameter/
Range Explanation
D1:Time (Delay 1 Time)
D2:Time (Delay 2 Time)
1ms–1700ms,
BPM –BPM
This determines the delay time.
When set to BPM, the value of each parameter will be set according
to the value of the “Master BPM” (p. 122) specified for each patch.
This makes it easier to achieve effect sound settings that match the
tempo of the song.
When setting to BPM, press [CATEGORY/ENTER] to display the
MASTER BPM screen.
If no operation if performed within a set period of time, the display
returns to the Delay screen.
• If, due to the tempo, the time is longer than the range of allowable
settings, it is then synchronized to a period either 1/2 or 1/4 of that time.
• After setting D1:Time or D2:Time to a value from 1 ms to 1,700 ms, you
can press [CATEGORY/ENTER] to set the value for D1:Time or D2:Time
to a value from 1 ms to 1,700 ms according to the interval you press the
button.
When Type is set to Dual-S or Dual-P, D1:Time is not changed.
D1:Fbk (Delay 1 Feedback)
D2:Fbk (Delay 2 Feedback)
0–100
Adjusts the amount of feedback of the Delay
1 (or Delay 2). A higher value will increase
the number of the delay repeats.
D1:HiCut (Delay 1 High Cut Filter)
D2:HiCut (Delay 2 High Cut Filter)
700Hz–11.0kHz,
Flat
This sets the frequency at which the high
cut filter begins to take effect. When “Flat”
is selected, the high cut filter will have no
effect.
D1:Level (Delay 1 Level)
D2:Level (Delay 2 Level)
0–120
Adjusts the volume of the Delay1 (or Delay
2).
Warp
Parameter/
Range Explanation
Warp Sw
Off, On
Turns the Warp effect on/off.
This parameter is assigned to the CTL1, CTL2 or CTL
3/4 jack.
Rise Time
0–100
Adjusts how rapidly the warped delay sound
rises.
F.B.Depth (Feedback Depth)
0–100
Adjusts the feedback level of the warped delay
sound.
Level Dep (Level Depth)
0–100 Adjusts the volume of the warped delay sound.
Modulate
Parameter/
Range Explanation
Mod.Rate (Modulate Rate)
0–100 Adjusts the modulation rate of the delay sound.
Mod.Depth (Modulate Depth)
0–100
Adjusts the modulation depth of the delay
sound.
GT-10B_e.book 120 ページ ２００８年２月２６日 火曜日 午後３時３０分