Boss Audio Systems GT-10B - Manual (Page 11)

11
Names of Things and What They Do
1. Display
Various information about the GT-10B is shown here.
The display screen on the left side shows the bank
number.
2. OUTPUT LEVEL Knob
This adjusts the volume level at the OUTPUT jack and
the PHONES jack.
3. OUTPUT SELECT Button
This adjusts the characteristics of the output from the GT-
10B to match the type of equipment that is connected (p. 26).
4. SYSTEM Button
This makes global settings mainly, for the GT-10B (p. 63).
5. EZ TONE
CREATE Button
This makes it easy to create tones based on the musical
genre and the feel of the song you have in mind (p. 33).
EDIT Button
This provides a simple way to modify tones (p. 33).
6. Parameter Knobs P1 Through P4
These change the values of the parameter shown on the
display.
7. Dial
This switches patches and modifies values.
[ ], [ ], [ ], and [ ] (Cursor Buttons)
These move the onscreen cursor up, down, or to the left
or right.
8. EFFECTS SELECT
Use these buttons to switch effects on or off, or to change
their settings (p. 34). When an effect is switched on, the
button’s indicator lights up; the indicator goes out when
the effect is off.
* [MASTER/PEDAL FX] does not light up.
COMP (Compressor) Button
OD/DS (Overdrive/Distortion) Button
PREAMP Button
EQ (Equalizer) Button
FX-1 Button
FX-2 Button
DELAY Button
CHORUS Button
REVERB Button
MASTER/PEDAL FX (Master/Pedal Effect) Button
9. SELECT Button
These switch between the A and B channels for the
Effects.
10. DISPLAY MODE Button
Allows you to change the way things are shown in the
display (p. 25).
11. EXIT Button
Use this to go back to the previous screen or to cancel an
operation.
Front Panel
BPM
PHRASE LOOP
ON / OFF
3
4
7
9
10 11 12
13 14
15
16
19
1
2
6
8
17 18
20
21
5
GT-10B_e.book 11 ページ ２００８年２月２６日 火曜日 午後３時３０分