Boss Audio Systems GT-10B - Manual (Page 85)

85
Chapter 6 Using the GT-10B with External MIDI Devices Connected
Chapter
6
This makes the settings for the channels used for MIDI information.
This sets the MIDI channel used for transmitting MIDI messages.
This sets the MIDI Device ID used for transmitting and receiving Exclusive messages.
This setting determines the basis used for synchronizing the timing for effect modulation rates and other time-based parameters.
Setting the MIDI Omni Mode
1. Follow the procedure in “Making the Settings for MIDI Functions” (p. 84) to
move the cursor to “Omni Mode.”
2. Set the desired
value.
Omni On
Messages are received on all channels, regardless of
the MIDI channel settings.
Even when Omni Mode is set to “Omni On”, the
only Exclusive messages received are for Device
ID data set with “Device ID.”
Omni Off
Information is received on the channel specified by
the Rx Channel setting.
Setting the MIDI Transmit Channel
1. Follow the procedure in “Making the Settings for MIDI Functions” (p. 84) to
move the cursor to “Tx Channel.”
2. Set the desired
value.
1–16, Rx
When set to “Rx,” this MIDI channel is same as the
MIDI Receive channel.
Setting the MIDI Device ID
1. Follow the procedure in “Making the Settings for MIDI Functions” (p. 84) to
move the cursor to “Device ID.”
2. Set the desired
value.
1–32
Setting the MIDI Sync Clock
1. Follow the procedure in “Making the Settings for MIDI Functions” (p. 84) to
move the cursor to “Sync Clock.”
2. Set the desired
value.
Auto
Operations are synchronized to the MIDI Clock re-
ceived via MIDI. However, operations are automati-
cally synchronized to the GT-10B’s internal Clock if
the GT-10B is unable to receive the external Clock.
• When you have an external MIDI device
connected, the Master BPM is then
synchronized to the external MIDI device’s
tempo, thus disabling the Master BPM setting.
To enable setting of the Master BPM, set to
“Internal.”
• When synchronizing performances to the MIDI
Clock signal from an external MIDI device,
timing problems in the performance may occur
due to errors in the MIDI Clock.
Internal
Operations are synchronized to the GT-10B’s internal
Clock.
GT-10B_e.book 85 ページ ２００８年２月２６日 火曜日 午後３時３０分