Boss Audio Systems GT-10B - Manual (Page 32)

32
Chapter 1 Outputting Sounds
The GT-10B includes a function that allows you to categorize patches into a number of different groups. This is called the
CATEGORY function (p. 40). Specifying the category for each patch makes searching for patches more convenient.
On the GT-10B, the master equalizer parameters are assigned to the PARAMETER knobs of the Play screen by default.
You can use these PARAMETER knobs to adjust the sound quality globally, for all patches.
Using the Dial to Select the Patch
1. Select the Patch.
On the GT-10B, you cannot switch patches in any
screen other than the Play screen. Press [EXIT] to
return to the Play screen (p. 25).
Separating Patches into Groups (CATEGORY)
1.
The CATG screen appears.
The categories and the patches in these categories are shown in list
format.
• On the GT-10B, you cannot enter the CATG
screen in any screen other than the Play screen.
Press [EXIT] to return to the Play screen (p. 25).
• You can also display the CATG screen from
PATCH SEARCH in the SYSTEM screen.
2. Select the category.
3. The GT-10B switches to the selected patch.
Adjusting a Tone
1. Select the Patch.
2.
P1 knob: Adjust the low frequency range tone.
P2 knob: Adjust the middle frequency range tone.
P3 knob: Adjust the high frequency range tone.
GT-10B_e.book 32 ページ ２００８年２月２６日 火曜日 午後３時３０分