Boss Audio Systems GT-10B - Manual (Page 108)

108
Chapter 8 Parameters Guide
The limiter attenuates loud input levels to prevent distortion.
This adjusts the tone as a equalizer. You can adjust the sound
quality in ten bands.
Adjusts the tonal quality. You can adjust the sound quality in
four bands.
SUB LIMITER
Parameter/
Range Explanation
Type
Selects the limiter type.
BOSS Limitr This selects a stereo limiter.
Rack 160D This models a dbx 160X.
Vtg Rack U This models a UREI 1178.
Attack
0–100 Adjusts the attack time.
Threshold
0–100
Adjust this as appropriate for the input signal
from your bass. When the input signal level ex-
ceeds this threshold level, limiting will be ap-
plied.
Ratio
1:1– ∞ :1
This selects the compression ratio used with
signals in excess of the threshold level.
Release
0–100 Adjusts the release time.
Level
0–100 Adjusts the volume.
GRAPHIC EQ (Graphic Equalizer)
Parameter Range
31Hz
-12–+12dB
62Hz
125Hz
250Hz
500Hz
1kHz
2kHz
4kHz
8kHz
16kHz
Level -12–+12dB
PARA EQ (Parametric Equalizer)
Parameter/
Range Explanation
Low Cut (Low Cut Filter)
Flat,
55Hz–800Hz
This sets the frequency at which the low cut fil-
ter begins to take effect. When “Flat” is select-
ed, the low cut filter will have no effect.
Low Gain
-20–+20dB Adjusts the low frequency range tone.
Lo-Mid f (Low Middle Frequency)
20.0Hz–10.0kHz
Specify the center of the frequency range that
will be adjusted by the “Lo-Mid G.”
Lo-Mid Q (Low Middle Q)
0.5–16
Adjusts the width of the area affected by the EQ
centered at the “Lo-Mid f.” Higher values will
narrow the area.
Lo-Mid G (Low Middle Gain)
-20–+20dB Adjusts the low-middle frequency range tone.
Hi-Mid f (High Middle Frequency)
20.0Hz–10.0kHz
Specify the center of the frequency range that
will be adjusted by the “Hi-Mid G.”
Hi-Mid Q (High Middle Q)
0.5–16
Adjusts the width of the area affected by the EQ
centered at the “Hi-Mid f.” Higher values will
narrow the area.
Hi-Mid G (High Middle Gain)
-20–+20dB Adjusts the high-middle frequency range tone.
High Gain
-20–+20dB Adjusts the high frequency range tone.
High Cut (High Cut Filter)
700Hz–11.0kHz,
Flat
This sets the frequency at which the high cut fil-
ter begins to take effect. When “Flat” is select-
ed, the high cut filter will have no effect.
Level
-20–+20dB Adjusts the volume before the equalizer.
GT-10B_e.book 108 ページ ２００８年２月２６日 火曜日 午後３時３０分