Boss Audio Systems GT-10B - Manual (Page 109)

109
Chapter 8 Parameters Guide
Chapter
8
This is an effect that clarifies the contour of the input sound by
emphasizing the attack of the sound following changes in the
input level.
This changes the tone of the connected bass.
Simulation of the characteristics of particular bass components
such as pickups and different bass bodies allows you to switch
among a number of different bass types all while using a single
bass.
ENHANCER
Parameter/
Range Explanation
Sens (Sensitivity)
0–100
This adjusts the Enhancer sensitivity. The more
the value is increased, the more softly you can
play and still have the effect applied.
Low Freq (Low Frequency)
31.5Hz–125Hz
Sets the low frequency range for the enhanced
sound.
Low Lev (Low Level)
0–100
Adjusts the enhancer volume for the high fre-
quency range.
High Freq (High Frequency)
800Hz–8.00kHz
Sets the high frequency range for the enhanced
sound.
High Lev (High Level)
0–100
Adjusts the enhancer volume for the high fre-
quency range.
TONE MODIFY
Parameter/
Range Explanation
Type
Selects the type of tone modification.
Fat Fat tone with boosted mid range.
Presence Bright tone with boosted high-mid range.
Mild Mild tone with the high end cut back.
Tight Tone with the low frequencies cut.
Enhance Tone with the high frequencies boosted.
Resonator 1, 2, 3
This produces a tone with greater power and
punch by adding resonance in the low-frequen-
cy range and midrange.
Resonance
0–100
This adjusts the strength of the low-end and
midrange resonance when Type is set to Reso-
nator 1, 2, or 3.
Low
-50–+50 Adjusts the tone for the low frequency range.
High
-50–+50 Adjusts the tone for the High frequency range
Level
0–100 Adjusts the volume.
BASS SIM. (Bass Simulator)
Parameter/
Range Explanation
Type
Selects the type of the bass simulator.
‘ PAS ’ > ‘ ACT ’
Changes from a passive type pickup tone to an
active type pickup tone.
‘ ACT ’ > ‘ PAS ’
Changes from an active type pickup tone to a
passive type pickup tone.
‘ SGL ’ > ‘ HUM ’
Changes from a single-coil pickup tone to a
humbucking pickup tone.
‘ HUM ’ > ‘ SGL ’
Changes from a humbucking pickup tone to a
single-coil pickup tone.
‘ SLD ’ > ‘ HLW ’
Changes a solid body bass tone to a hollow
body bass tone with the body resonance added.
‘ SGL ’ > ‘ ACO ’
Changes a single-coil pickup tone to an acoustic
bass tone.
‘ HUM ’ > ‘ ACO ’
Changes a humbucking pickup tone to an
acoustic bass tone.
Low
-50–+50 Adjusts the tone for the low frequency range.
High
-50–+50 Adjusts the tone for the High frequency range
Body
0–100
Adjusts the way the body sounds when Type is
set to ‘SLD’>‘HLW’, ‘SGL’>‘ACO,’ or
‘HUM’>‘ACO.’
The body sound increases as the value is raised;
reducing the value produces a tone similar to
that from a piezo pickup.
Level
0–100 Adjusts the volume.
GT-10B_e.book 109 ページ ２００８年２月２６日 火曜日 午後３時３０分