RADWAG MYA 5.3Y.F1 Microbalance - Manual (Page 28)

- 28 -
indication returns to autozero zone, the software automatically
deactivates Tare value.
− Automatic footer printout
Accessible options:
MODE - No – manual footer printout,
Sum of measurements – the condition for printing a footer is
exceeding mass value set in parameter
Number of measurements – the condition for printing a footer
is carrying out a pre-defined number of measurements (a
batch) set in parameter
THRESHOLD – setting the value of threshold determining footer
printout.
For option the value is determined
in measuring unit [g], and for option
measurements> the value is not measurable, and determined
by number of carried out measurements.
− Printout mode / printout release
•
Function key PRINT / printout release, (manual operation)
Never – printout deactivated
First stable – the first stable measurement is printed
Each stable – all stable measurements are set for printing
Each – printout of all measurements (stable and
unstable), in case of a verified balance only stale
measurement results are printable (as in setting
)
•
AUTOMATIC MODE
Never – printout deactivated
First stable – the first stable measurement result obtained after
placing a load on balance’s weighing pan is recorded,
record of the following measurement result takes
place only on unloading the weighing pan, returning
of the mass indication below set threshold’s value,
and placing another load on balance’s weighing pan
Last stable – accepted is the last stable measurement recorded
before taking the load off the weighing pan. The
record takes place on taking the load off the
balance’s weighing pan, and returning of the mass
indication below set threshold’s value.
•
THRESHOLD
mass value obligatory for operation of automatic printout. Set in
grams.