RADWAG MYA 5.3Y.F1 Microbalance - Manual (Page 177)

- 177 -
Example1
Command:
OMI – give available working modes
Response:
OMI – available working modes are given
2_” Parts counting” number + name
4_” Dosing”
12_”Checkweighing”
OK – command completed
Example2
Command:
OMI – give available working modes
Response:
OMI – available working modes are given
2 (mode number)
4
12
OK – command completed
OMS - Set working mode
Command sets current working mode of a balance.
Format: OMS_n
Accessible responses:
OMS_OK – command completed
OMS_E – error occurance in course of command
performance, incorrect format or lack of the
parameter
OMS_I – command understood but not accessible at this
moment
n – parameter, decimal value specifying working mode number. See OMI
command description for detailed information.
Example
Command:
OMS_13 – set Statistics mode
Response:
OMS_OK – Statistics mode selected
OMG - give current working mode
Command gives current working mode for a given device.
Format: OMG
Accessible responses:
OMG_n_OK – command completed, current working mode is