Festo Кабели и принадлежности - Manual (Page 74)

4. Commissioning
4−29
Festo P.BE−SPC200−SMX−1−EN en 0503b
Axis parameters
Menu AXIS PARAM Set the following parameters (description of the parameters
see section Commissioning with WinPISA"):
Menu AXIS PARAM (axis parameters)
CYL. LENGTH Length of drive
Application parameters
Menu APPLIC PARAM Set the following parameters (description of the parameters
see section Commissioning with WinPISA"):
Menu APPLIC PARAM (application parameters)
RESOLUTION Resolution
START/STOP FREQ Start−stop frequency
POS. BASEPOINT Project zero point
LOWER END POS. Lower software end position
UPPER END POS. Upper software end position
REFER. POSIT. Reference position
REFER. SPEED Reference speed factor
MAX. SPEED Maximum speed
MAX. ACCELER. Maximum acceleration
MODE OF REFER. Reference travel mode
MICRO/HALF STEP Step mode (Micro/Half step)
Ĉ with SEC−ST−...: always 0
Ĉ with MRC−...: 0 or 1
(see following sections)