Festo Кабели и принадлежности - Manual (Page 48)

4. Commissioning
4−3
Festo P.BE−SPC200−SMX−1−EN en 0503b
4.1 Procedure for commissioning
For user−friendly commissioning and programming of an
SPC200 with stepping motor indexermodule, you will require
the WinPISA software package as from version 4.3.
However, commissioning can also be carrried out by means of
the control panel.
The following list provides an overview of the steps required
for commissioning:
1. Check the stepping motor controller. Set the necessary
parameters on the stepping motor controller. Check the
function and arrangement of the limit switches.
Provide the necessary system inputs on the SPC200
(seeĂPreparingĂcommissioning).
General commissioning of the SPC200:
2. First check and save the hardware configuration of the
SPC200 (see WinPISA or SPC200 manual).
Commissioning the stepping motor axes:
3. Set the axis and application parameters for the stepping
motor axes to be used.
4. Check the function of the stepping motor axes:
ć Inputs (reference and limit switches)
ć Rotational direction of the stepping motor
ć Positioning the axis
ć Reference travel
5. Check that each axis has been correctly commissioned by
means of a simple test program.