Festo Кабели и принадлежности - Manual (Page 72)

4. Commissioning
4−27
Festo P.BE−SPC200−SMX−1−EN en 0503b
4.4 Commissioning with the control panel
If you wish to carry out commissioning with the control panel
type SPC200−MMI−1, you should be familiar with the functions
of the control panel. Leave the power supply for the stepping
motor controller (if necessary, also the compressed air supĆ
ply) switched off. An overview of the menu system on the
control panel can be found in the user manual for the
SPC200.
Please note
The control panel type SPC200−MMI−.. does not support all
new or extended functions of the SPC200 with firmware as
from version 4.6.
The prerequisite for commissioning a stepping motor axis is
that the current hardware configuration of the SPC200 is
saved (see user manual for the SPC200).
Proceed here as described in the following sections.