Festo Кабели и принадлежности - Manual (Page 43)

3. Installation
3−8
Festo P.BE−SPC200−SMX−1−EN en 0503b
3.3 Connecting the stepping motor controller and the stepping motor
Fit the stepping motor controller and the motor cable in
accordance with the accompanying description.
Please note
In order to comply with EMC, a mains filter may have to be
installed between the mains supply cable and the stepping
motor controller.
3.4 Connecting the control cable
There is a sub−D plug on the stepping motor indexer module
for connecting the SPC200 to the stepping motor controller
(AMPLIFIER, X30).
This plug has been designed for stepping motor controllers
with 5 V control signals.
Use the special cables from the Festo range for connecting
the stepping motor controller.
If you use a stepping motor controller from a different manuĆ
facturer, you must prepare a cable in accordance with the
manufacturer’s instructions.
In this case, connect the cable screening on both sides with
the plug housing.