Festo Кабели и принадлежности - Manual (Page 53)

4. Commissioning
4−8
Festo P.BE−SPC200−SMX−1−EN en 0503b
Fig. 4/2: Parameter set for the .. axis, register card
AxisĂparameters"
4.3.1 Selecting a specification for the axis
A large number of settings and parameters must be defined
for an electric axis.
Specifications for drive packages can be selected for this purĆ
pose. The specifications are saved in planning files (*.pta). A
series of typical specifications can be found in the delivery
scope of WinPISA. You can create these specifications yourĆ
self with the aid of the Planning Tool (PtTool).
Information on further necessary entries can be found in the
following sections.