Festo Кабели и принадлежности - Manual (Page 14)

Contents and general instructions
XII
Festo P.BE−SPC200−SMX−1−EN en 0503b
List of abbreviations
The following product−specific terms and abbreviations are
used in this manual:
Term/abbreviation Meaning
Drive package Stepping motor controller, in some cases with gear
Electric axis Combination of motor, coupling (coupling housing with coupling and
flange), electromechanical linear axis, as well as the necessary
cables and sensors.
Electromechanical
Linear drive Linear guide with spindle or toothed−belt drive
I Digital input
I/Os Digital inputs and outputs
Modules Function cards which can be plugged into the rack of the SPC200.
Q Digital output
Record Select mode Operating mode of the SPC200 which supports close coupling with a
higher−order PLC/IPC.
Resolution Steps per mm positioning path, depends on the motor used, the
drive as well from the configured step mode (see section 4.3.3).
Start−stop frequency Frequency with which the stepping motor can start and stop reliably
at the required rotational speed (without loss of step).
Start/Stop mode Operating mode of the SPC200 which supports both autonomous
operation and control by a higher−order PLC/IPC.
Step mode The step mode defines the step width (rotary angle of the motor per
impulse). Therefore the steps per turn are defined too.