Festo Кабели и принадлежности - Manual (Page 33)

2. Fitting
2−7
Festo P.BE−SPC200−SMX−1−EN en 0503b
2.2 Fitting the electric axis and the stepping motor controller
Notes on fitting the electric axis and the stepping motor
controller can be found in the following documentation:
ć the documentation supplied with the stepping motor
controller,
ć the pneumatics manual for the positioning system type
P.BE−ATP−...,
ć the operating instructions for the electric linear axis used,
ć the instructions for the components used.
Please note
By the arrangement of the limit switches and by additional
appropriate mechanical stops, make sure that the axis
always lies within the positioning range limited by the
hardware limit switches.
Use the correct type of switch for the necessary reference and
limit switches:
Sensor Contact
Reference switch N.O. = normally open
Limit switches N.C. = normally closed