Festo Кабели и принадлежности - Manual (Page 32)

2. Fitting
2−6
Festo P.BE−SPC200−SMX−1−EN en 0503b
1
Direction for
unlocking
2
Locks
automatically
3
Retaining lever
4
Front plate of the
module
5
Terminal strip
6
Guide rail
1
2
3
4
5 6
1
Fig. 2/1: Installing the modules
Removing modules Proceed as follows when removing a module:
1. Switch off the operating voltage and the compressed air
supply.
2. Loosen and pull off the connecting cable on the front of
the module.
3. Unlock both locking levers (see diagram) and carefully
pull out the module.
4. If necessary, seal the unused slots with blanking plates.