Festo Кабели и принадлежности - Manual (Page 19)

1. System summary
1−5
Festo P.BE−SPC200−SMX−1−EN en 0503b
Module Description
Power supply module Enables the power supply and the axis
interface designed as a field device to be
connected.
Diagnostic module Enables the control panel to be fitted
and a PC to be connected.
I/O or field bus module Enables control of the I/Os or
communication via the field bus.
Stepping motor indexer
module Enables a stepping motor controller to
be controlled.
A system structure with the modules shown above offers the
following facilities:
ć One or two pneumatic axes can be controlled
ć Control of one stepping motor axis
ć Programming and diagnosis via a PC or a control panel
ć Coordination via I/Os or via the field bus
Providing a sufficient number of unused locations are availĆ
able, up to 3 stepping motor indexer modules can be fitted in
the SPC200 for controlling 3 electric axes.
The SPC200 can be controlled via I/Os or via the field bus in
the operating mode Start/Stop or in the Record Select mode.
The address range required for this is provided by the I/O
module or the field bus module.