Festo Кабели и принадлежности User Manual

Page 69

4. Commissioning

4−24

Festo P.BE−SPC200−SMX−1−EN en 0503b

Fig. 4/7: Dialogue window Commission stepping motor"

Checking the inputs

2. Make sure that the end and reference switches function

correctly. In order to do this, you can move the axis by
hand when the stepping motor controller is switched off.

Select the desired stepping motor axis under Axis
selection." Check the checkboxes of the relevant inputs
under Status of the inputs."

Note the different designs of sensors:

Limit switches (end switches): N.C., normally closed

Reference switch: N.O., normally open