HID EntryProx Installation Guide - Manual (Page 8)

Part No. 4045-905, Rev C.2 EntryProx
™
User Guide
3 INSTALLATION
You can install the EntryProx unit by using a standard installation
method or a secure installation method. Both installation methods
require that you mount the EntryProx unit to a wall or glass
surface.
3.1 ASSEMBLY PARTS
Before you install the EntryProx, be sure that you have the correct
factory and installer supplied parts.
A. Controller Keypad Unit I. Silicone Rubber Cushion
B. Controller Keypad
Backplate J. Self-Adhering Pads
C. Cable Assemblies K. 2-pin Jumper †
D. Antenna Backplate L. Filler Piece
E. Antenna Housing M. Lithium “Coin Cell” Battery (see page
10 for the Battery Caution statement)*
F. Blank Label
G. Mounting Screws N. Cover screws – hex and tamper.*
H. Press to Exit Label O. Hex wrench*
* - not shown in Figure 1
† - pre-installed on main board connector P2, pins 5 & 6
Page 8 of 58 February 7, 2007
© 2007 HID Global Corporation. All rights reserved.