HID EntryProx Installation Guide - Manual (Page 13)

EntryProx™ User Guide Part No. 4045-905, Rev C.2
5. Reattach the main circuit board to the controller keypad
unit.
6. Attach the controller keypad unit to the mounted
backplate and secure the EntryProx unit with a hex
screw or tamper screw.
Note: A ribbon cable holds the main circuit board to the controller
keypad board. DO NOT CUT OR REMOVE this cable from its
connector.
Figure 4 Removing the Circuit Board
February 7, 2007 Page 13 of 58
© 2007 HID Global Corporation. All rights reserved.