HID EntryProx Installation Guide - Manual (Page 10)

Part No. 4045-905, Rev C.2 EntryProx
™
User Guide
CAUTION – Replace Battery with Panasonic BR1225 only.
Use of another battery may present a risk of fire or
explosion. Battery may explode if mistreated. Do not
recharge, disassemble or dispose of battery in fire.
4 MOUNTING
If you mount the EntryProx unit to a wall, you can install an
electrical junction box to hold the unit and the wires in place. The
mounting hole cutouts on the backplate line up with the screw
holes on a standard junction box.
If you mount the EntryProx unit to a glass surface, DO NOT
remove the wire exits on the backplate. Remove the appropriate
wire exit cutouts located on each side of the controller keypad
case.
If your installation must comply with the UL 294 Standard
for Access Control, please read Page 14.
4.1 PRECAUTIONS FOR OUTDOOR
INSTALLATIONS
Water damage is a key cause of unit malfunction, causing
corrosion or short circuits. When mounting the unit in an area
that will be exposed to rain or moisture, take the following
precautionary measures:
1. Use silicone to seal wire runs and mounting holes
(antenna is already sealed).
2. Do NOT seal the cover and base together. Water that
enters the case must be allowed to run out at the
bottom.
3. Bend the wires to form a drip loop before they enter the
case. This will prevent water from following the wires
into the case.
Page 10 of 58 February 7, 2007
© 2007 HID Global Corporation. All rights reserved.