HID EntryProx Installation Guide - Manual (Page 21)

EntryProx™ User Guide Part No. 4045-905, Rev C.2
3. Remove the backing sheet from the tape on the
magnet and stick the magnet to the plastic spacer,
which is factory-installed to the back of the Keypad
board in location A (Figure 10).
4. Stick the reed switch on the inside of the long side of
the J-box in the upper right-hand corner, using the
adhesive tape. The switch should be flush with the
edge of the J-box.
4.9 WALL MOUNTING
1. Use an Ademco® PR-20451 magnet and reed switch
(or equivalent) with foam-backed adhesive tape.
2. Remove the backing sheet from the tape on the
magnet and stick the tape to the plastic spacer, which
is factory-installed to the back of the Keypad board at
location B (Figure 10).
3. Drill a 3/8 inch hole in the wall behind the magnet
location, feed the switch wire through the wall and
press the switch into place.
February 7, 2007 Page 21 of 58
© 2007 HID Global Corporation. All rights reserved.