HID EntryProx Installation Guide - Manual (Page 14)

Part No. 4045-905, Rev C.2 EntryProx
™
User Guide
4.4 CONTROLLER KEYPAD WIRING - SECURE
INSTALLATION
In a secure installation, the waterproof antenna housing is
removed from the controller keypad and mounted outside of a
secured area. The control unit is installed inside the secured area.
The blank filler piece is then inserted into the controller keypad in
its place. This is appropriate for exterior doors or “medium to
high-risk” locations.
To wire the EntryProx unit for a secure installation , refer to Figure
5 and Figure 6 and follow these instructions.
1. Touch a grounded object BEFORE touching the main
circuit board to guard against possible static
discharges.
2. Remove the main circuit board by pushing outward on
the two spring tabs in the direction shown in Figure 4.
3. Lift the main circuit board.
4. Unplug the four-pin cable assembly from connector P4
on the main circuit board.
5. Release the antenna housing from the controller
keypad by pressing inward on the four securing tabs.
6. Remove the antenna housing from the controller
keypad by pushing forward as shown in Figure 6.
7. Insert the extra 10-inch antenna cable assembly into
connector P4.
8. Splice in additional antenna cable Alpha 1174C
(22AWG) up to a maximum of 10 feet.
Note: The Alpha 1174C antenna cable is not supplied with the
EntryProx unit.
Page 14 of 58 February 7, 2007
© 2007 HID Global Corporation. All rights reserved.