HID EntryProx Installation Guide - Manual (Page 18)

Part No. 4045-905, Rev C.2 EntryProx
™
User Guide
5. Attach the antenna housing to the backplate by
inserting the four securing tabs into the backplate.
6. Seal the wire holes with silicone.
4.6 FILLER OR REQUEST TO EXIT LABEL
The filler piece replaces the antenna housing on the controller
keypad when you use the high security installation. If you do not
plan to use the filler piece as a Request to Exit switch:
1. Insert the filler piece into the opening on the controller
keypad.
2. Apply the blank label.
Figure 8 Attaching the Antenna Housing
Page 18 of 58 February 7, 2007
© 2007 HID Global Corporation. All rights reserved.