HID EntryProx Installation Guide - Manual (Page 33)

EntryProx™ User Guide Part No. 4045-905, Rev C.2
Cards with multiple facility codes or many numbering gaps must
be entered by presentation to the reader, using Command 53.
If the Batch Loading conditions can be met:
1. Place the EntryProx unit in program mode.
Press: 99 # Master Code *
2. On the EntryProx keypad
Press: 56 # (total number of cards to be added) #
(starting user location) # card number *
repeat card number *
3. Press * to exit program mode.
7.7 BATCH LOAD BY PRESENTATION
Use Command 53 to program a batch of cards into consecutive
User Locations by specifying the starting User Location, then
presenting cards or tags to the reader. Use any card format up to
37 bits. All cards are programmed alike and users are “card only.”
Card enrollment stops once the current user location exceeds
2000, or if you press any key to abort. Keep a written record as
you program cards.
Existing data in the User Locations being programmed is
overwritten, unless you present a card that is already programmed
into the EntryProx, in which case an error is generated. To clear
the error, press the * key; then continue presenting cards.
To batch load by presentation, follow this procedure:
1. Place the EntryProx unit in program mode.
Press: 99 # Master Code *
USER TYPES - REMINDER
0-Toggle 1-Normal 2-Download 3-Lockout
February 7, 2007 Page 33 of 58
© 2007 HID Global Corporation. All rights reserved.