HID EntryProx Installation Guide - Manual (Page 49)

EntryProx™ User Guide Part No. 4045-905, Rev C.2
12 PROGRAMMING COMMANDS
Read the following table before completing programming of your
EntryProx unit; it describes various programming commands and
how to execute them. As with the previously described
commands, you must first press 99 # (Master Code) * to enter
programming mode, enter the desired command sequence, and
then press * to exit programming mode. “Ref” number is for
reference only, not to provide an ordered sequence of commands.
Table 1 Programming Commands
IF YOU WANT Ref PRESS DETAILS
TO
1 Enter program
mode
99 # (Master
Code) * yellow LED blinks slowly
2 Program new
master code into
user location 0
50 # 1 # 0000 #
master code *
master code * example: 4321 master code
(50 # 1 # 0000 # 4321 * 4321
*)
3 Set main relay
time 11 # tt # 0 # ** tt = 1 - 99 seconds
4 Set AUX relay
output 15 # output
mode Output Modes:
0 = disabled,
# 0 # **
1 = shunt,
2 = forced door,
3 = propped door
5 Delete users User Location #
** Example:
To delete user 100, press:
100#**
6 Download a
transaction Log
70 # 0 # 0 # ** Hold optional Palm PDA
IR receiver near the
EntryProx IR LED.
February 7, 2007 Page 49 of 58
© 2007 HID Global Corporation. All rights reserved.