HID EntryProx Installation Guide - Manual (Page 30)

Part No. 4045-905, Rev C.2 EntryProx
™
User Guide
No User Location can have the same card and/or access PIN
code as another User Location.
6.9 ENTERING USER PIN CODES
EntryProx user PIN codes consist of a minimum of one digit and a
maximum of six digits. Note that a leading “0” is considered a digit,
and that the 5-digit code 12345 is different from the six-digit code
012345. Attempting to enter a user PIN code into memory that is
already stored in a different user location causes the yellow LED
to stop blinking and remain steadily lit. If this occurs, try entering a
different user code. Repeating digits in the same code is
acceptable (ex: 121122).
7 CARD/PIN PROGRAMMING
SEQUENCES
Following are the most commonly used command sequences for
programming user data into the EntryProx.
7.1 PROGRAMMING PIN + CARD
To program a user for both Code AND Card:
1. Place the EntryProx unit in program mode.
Press: 99 # Master Code *
2. On the EntryProx keypad
Press: 50 # user-type # user location # keypad PIN
* keypad PIN *
3. Press * to exit program mode.
Here is an example, assuming a master code of 2468 and
programming user 2 with PIN 1111
99#2468* Press
50#1#2#1111*1111* Press
Press
*
Page 30 of 58 February 7, 2007
© 2007 HID Global Corporation. All rights reserved.