HID EntryProx Installation Guide - Manual (Page 41)

EntryProx™ User Guide Part No. 4045-905, Rev C.2
9.2 SELECTING TRANSACTION LOG
INFORMATION
You can selectively program specific transaction events to be
included (or not) on the Transaction Log. By “masking” out certain
events, you direct the unit not to save those events in memory and
thus they do not appear in the log. The factory default is for all
transaction events to be saved in memory and included in the log.
The procedure follows:
1. Place the EntryProx unit in program mode.
Press: 99 # Master Code *
2. To turn OFF an event (keep it from being
stored/logged)
Enter: 73 # Event Code # 0 # **
3. To turn an event ON
Enter: 73 # Event Code # 1 # **
4. Press * to exit program mode.
The Event Code is a two-digit number that represents a specific
transaction as listed in the following table.
February 7, 2007 Page 41 of 58
© 2007 HID Global Corporation. All rights reserved.