HID EntryProx Installation Guide - Manual (Page 37)

EntryProx™ User Guide Part No. 4045-905, Rev C.2
Note: You must change the master code after performing this
command.
1. Place the EntryProx unit in program mode.
Press: 99 # Master Code *
2. Press: 40 # 00000 # 00000 # **
3. Press * to exit program mode
8.4 ERASING ENTIRE MEMORY / RESETTING
SYSTEM DEFAULTS
Command 46 deletes everything from the EntryProx memory
including the user list but not the transaction log and restores the
default settings. This is used as a last resort if you need to erase a
specific user and could not retrieve the Programmed User List.
After performing this command the master code must be
reprogrammed.
1 Place the EntryProx unit in program mode.
Press: 99 # Master Code *
2. Press: 46 # 00000 # 00000 # **
3. Press * to exit program mode.
8.5 TURNING KEYPRESS AUDIBLE
FEEDBACK ON/OFF
The Keypress Audible Feedback command enables the sounder
to beep once for each key press. This feature provides an audible
acknowledgment that a particular key was pressed hard enough
for the unit to understand. The factory-shipped default setting is
ON, but it can be toggled ON and OFF as desired using command
30
.
1. Place the EntryProx unit in program mode.
Press: 99 # Master Code *
2. To enable this feature
Press: 30 # 0 # 1 # **
February 7, 2007 Page 37 of 58
© 2007 HID Global Corporation. All rights reserved.