HID EntryProx Installation Guide - Manual (Page 38)

Part No. 4045-905, Rev C.2 EntryProx
™
User Guide
3. To disable this feature
Press: 30 # 0 # 0 # **
4. Press * to exit program mode
8.6 TURNING KEYPRESS VISUAL FEEDBACK
ON/OFF
The keypress visual feedback feature lights the LED once for each
key press. This feature provides a visual acknowledgment that a
particular key was pressed hard enough for the unit to understand.
The factory-shipped default setting is ON, but it can be toggled ON
and OFF as desired.
1. Place the EntryProx unit in program mode.
Press: 99 # Master Code *
2. To enable this feature
Press: 30 # 1 # 1 # **
3. To disable this feature
Press: 30 # 1 # 0 # **
4. Press * to exit program mode
8.7 AUTO ENTRY ENABLE
This function is not recommended for use, as it lowers the overall
security of the unit and affects programming sequences ending
with the * key. It is set with the 30# command (Set/Clear Standard
Options). When this feature is enabled, any PIN code the same
length as the master code does not require the * key. Leave this
feature in the default mode, which is OFF.
Page 38 of 58 February 7, 2007
© 2007 HID Global Corporation. All rights reserved.