HID EntryProx Installation Guide - Manual (Page 4)

Part No. 4045-905, Rev C.2 EntryProx
™
User Guide
1 INTRODUCTION
This User’s Guide provides information and instructions for
installing, wiring, and programming the EntryProx unit.
IMPORTANT
KEEP A USER LIST when programming cards and PIN
codes into your EntryProx. Write down the User Location,
Card Number, PIN Code and the Name of the User. Use
the blank form in Appendix A as a photocopy master.
•
T
CHANGE THE MASTER CODE
•
from the factory default
(User Location 1, PIN Code: 1234) to a new code (1-6
digits). Programming commands will not work until the
default Master Code is changed. Write the new code
down and keep it in a safe place.
PROGRAM THE NEW MASTER CODE INTO LOCATION
0
•
. Once this is done, the default Master Code in User
Location 1 can now be reprogrammed for normal access
control use. The Rev C EntryProx no longer reserves
User Location 1 for the Master Code.
IF YOU LOSE / FORGET THE MASTER CODE
•
End Users: contact your dealer –a service call is
required.
Dealers: call HID Technical Support.
CONSIDER A SECURE INSTALLATION if installing on an
exterior door or high-risk location
•
2 PRODUCT OVERVIEW
The EntryProx unit provides card and keypad access control for a
single entrance. The unit can be installed in a standard one-stage
configuration or a secure two-stage (remote) configuration.
(Secure installation will be card-only.)
To gain access to the controlled door, the user presents their card
to the reader and / or enters their PIN code into the keypad. The
unit searches its memory for that card or PIN code. If the unit
finds the card or PIN code, it unlocks the door or performs some
other action that has been programmed for that user.
Page 4 of 58 February 7, 2007
© 2007 HID Global Corporation. All rights reserved.