HID EntryProx Installation Guide - Manual (Page 5)

EntryProx™ User Guide Part No. 4045-905, Rev C.2
The EntryProx unit is compatible with all HID proximity access
cards or key tags encoded with up to 37 bits of data. All
programming options are performed using the controller keypad.
Manual or batch card/tag programming via the keypad can be
completed for 26-bit format only. A batch of cards or tags encoded
in any format can be sequentially presented to the reader by
entering a single keypad command.
The Rev C EntryProx can download card and transaction reports
via the IR LED to an optional Palm PDA. Previous product
versions downloaded to a thermal printer.
2.1 UNIT CAPACITY
The EntryProx unit can accommodate up to 2,000 users. Each
user is assigned to a User Location (numbered 1 – 2000), which
can have a card/key tag, a PIN code, or a card/key tag
PLUS a
PIN code. User Location 0 is reserved for the Master Code (used
for programming, only).
2.2 TRANSACTIONS
A maximum of 1,000 transactions can be stored in the EntryProx
unit. Each transaction includes the time, the date, the User
Location and the event. When maximum capacity is reached, the
oldest transactions are overwritten.
2.3 PRE-PROGRAMMING THE UNIT BEFORE
INSTALLATION
Dealers and installers are advised to pre-program the unit at their
offices before installing it at the site. Simply connect it to a 12VDC
source, follow configuration and card enrollment instructions at the
end of this guide, and disconnect the unit. Programming will be
retained in memory. You will spend less time at the site, and by
being familiar with programming, will be able to train the end user
more effectively.
February 7, 2007 Page 5 of 58
© 2007 HID Global Corporation. All rights reserved.