HID EntryProx Installation Guide - Manual (Page 17)

EntryProx™ User Guide Part No. 4045-905, Rev C.2
4.5 ANTENNA HOUSING - SECURE
INSTALLATION
Mount and wire the antenna housing no more than 10 feet away
from the controller keypad unit.
To mount and wire the antenna housing, refer to Figure 7 and
Figure 8 and follow these instructions.
1. Pull the additional antenna cable through the antenna
housing’s backplate cable holes.
Cable Holes
Moisture Release
Holes
Figure 7 Mounting the Antenna Backplate
2. Position and secure the antenna backplate to the
mounting surface so that the two moisture release
holes are on the bottom.
3. Cut the plastic connector off the antenna cable
assembly.
4. Splice in the additional antenna cable. Be careful to
match the wire colors to the proper pin connectors on
the 10-inch antenna cable assembly.
February 7, 2007 Page 17 of 58
© 2007 HID Global Corporation. All rights reserved.