HID EntryProx Installation Guide - Manual (Page 53)

EntryProx™ User Guide Part No. 4045-905, Rev C.2
IF YOU WANT Ref PRESS DETAILS
TO
20A Program new
master code into
user location 0
50 # 1 # 0000 #
master code *
master code *
21 Program card
user manually:
Card ONLY (26-
bit cards ONLY)
51 # user-type #
user location #
card ID * card ID
* the card ID appears on the
card (facility code must be
entered first; see 32 # 2 #
command)
22 Program user: 52 # user-type #
user location #
code* repeat
code *
Code OR Card
23 Program a group
of consecutive
users by
presenting cards
53 # user type #
start location #
** Programs card-only users.
Stops at user location 2000,
or press any key to abort.
Erases existing
programming. If an existing
card is presented, an error
will occur – press * to resume
…
24 Perform batch
entry of users:
Card ONLY (26-
bit cards ONLY)
56 # total count
# starting user the card ID appears on the
card; (facility code must be
entered first; see 32 # 2 #
command)
location #
starting card ID
* starting
card ID *
25 Block Delete
Users
58 # start user #
start user #
number of users
* number of
users * Yellow LED blinks rapidly;
allow several seconds for
large blocks of users.
Cannot delete: master user,
more than 2000 users, or
user location greater than
2000.
26 Quick Enroll Card User Location #
* * card>
February 7, 2007 Page 53 of 58
© 2007 HID Global Corporation. All rights reserved.