3 changing the master code – HID EntryProx Installation Guide User Manual

Page 27

EntryProx™ User Guide

Part No. 4045-905, Rev C.2

2. You have pressed the wrong key in a command

sequence

Press * to clear the error condition, then enter a new
code or PIN, or re-enter the command sequence as
required. If the unit does not go into program mode,
contact your dealer or HID Technical Support.

6.3

CHANGING THE MASTER CODE

The EntryProx cannot be programmed before you change the
master code. This feature prevents users from leaving the default
code in the unit; thereby preventing unauthorized programming
and tampering. The steps are:

1. Enter programming mode using the default master

code in User Location 1.

Press: 99 # 1234 *

2. Enter a new master code into User Location 0. Press:

50 # 1 # 0000 # new master code * new master code *
(Code can be 1 – 6 digits. This PIN is mirrored into
User Location 1)

3. Enter a new code into User Location 1. See CARD/PIN

PROGRAMMING SEQUENCES, page 30.

4. Press * to exit program mode.

You can now program any user type into User Location 1, or you
can simply delete it. User Location 0 is not an access code – it is
only used to enter programming mode. Although it is not
recommended, you can also program the same PIN used in User
Location 0 as an access code in another location – it is the only
code not checked for duplication.

It is also possible to change the master code and leave the master
code in user location 1, however, this is not recommended,
because the master code can be accidentally overwritten.

February 7, 2007

Page 27 of 58