HID EntryProx Installation Guide - Manual (Page 19)

EntryProx™ User Guide Part No. 4045-905, Rev C.2
If you plan to use the filler piece as a Request to Exit switch:
1. Remove the two plastic side tabs on the filler piece.
2. Insert the silicone rubber cushion over the two
alignment pins on the switch activator.
3. Apply the “Press to Exit” label to the filler piece.
4. Insert the filler piece into the opening on the controller
keypad.
5. Refer to Figure 11 to make the wiring connections to
the cable assembly if you are using a door contact.
6. Set the internal Request to Exit button ON, using
programming Command 30, option 7 (see Table 1
Programming Commands).
Cushion
Figure 9 Filler Piece and Request to Exit Switch
February 7, 2007 Page 19 of 58
© 2007 HID Global Corporation. All rights reserved.