HID EntryProx Installation Guide - Manual (Page 11)

EntryProx™ User Guide Part No. 4045-905, Rev C.2
4.2 BEGINNING ENTRYPROX INSTALLATION
To mount the EntryProx unit, referring to Figure 2 and Figure 3 ,
follow these instructions:
1. Remove the hex screw located at the bottom of the
EntryProx unit.
2. Disconnect the backplate of the EntryProx unit from the
controller keypad.
3. Remove the wire exits and mounting hole cutouts from
the backplate.
4, Pull the wires through the backplate.
5. Attach the backplate to a wall or glass surface using the
mounting screws or the self-adhesive fasteners.
Mounting Hole Cutouts
Wire Exits
Mounting Hole Cutouts
Figure 2 Removing Wiring Exits and Mounting Holes
February 7, 2007 Page 11 of 58
© 2007 HID Global Corporation. All rights reserved.