Allied Telesis AT-S25 - Manual (Page 98)

98
Creating a New VLAN
This section contains the procedure for creating a new VLAN in a stack.
The procedure explains how to assign a name to the VLAN and how to
specify which ports will be members of the new VLAN.
Note
For background information on VLANs, refer to Appendix A,
Introduction to Virtual LANs on page 139.
To create a new VLAN, perform the following procedure:
1. From the Main Menu, select a switch in the stack with ports that will
be members of the new VLAN. If the new VLAN will contain ports from
several switches in the stack, select any one of the switches.
2. From the Main Menu, select Virtual LANs/QoS.
Note
If the Omega Main Menu does not include the Virtual LANs/QoS
selection, the stack is operating in the Basic VLAN Mode. To create
VLANs, you must deactivate the Basic VLAN Mode, as explained in
Activating or Deactivating the Basic VLAN Mode on page 107.
The Virtual LAN/QoS menu in Figure 48 is displayed.
Figure 48 Virtual LAN/QoS Menu