Allied Telesis AT-S25 - Manual (Page 52)

52
2. From the Main Menu, select Administration.
The Administration menu in Figure 16 is displayed.
Figure 16 Administration menu
Note
If you are running a local management session, the Administrator
menu will contain two additional selections: XModem software
update to this system and Connect to a remote system.
3. Select Reset and restart the system.
The master switch will reset itself and the slave switches in the
stack. Each switch runs a series of self-tests, which take a few
seconds to complete. During the tests, the Fault LED on the front
of the switches will flash. Once the tests are completed, the Fault
LED will remain OFF.
The master switch begins a discovery process of the stack
topology, during which the number and types of switches that
constitute the stack are determined. This discovery process takes
approximately thirty seconds to complete. Once the discovery
process has been completed, the stack will begin to forward
packets.