Allied Telesis AT-S25 - Manual (Page 24)

24
Starting an Omega Session from a Web Browser
This section explains how to start an Omega session from a web
browser.
Note
An AT-8300 stack must have an IP address and subnet mask for you
to manage it using a web browser. Initially assigning an IP address
to a stack can only be performed from a local Omega management
session. If you have just install the stack and have yet to assign it an
IP address, start a local management session with the stack as
explained earlier in this chapter and then assign it an IP address and
subnet mask by performing the procedure Configuring IP
Parameters on page 38 in Chapter 2.
Note
You cannot use a web browser to manage an AT-8300 stack that is a
part of a non-TCP/IP network.
To start an Omega session using a web browser, perform the following
procedure:
1. Start your web browser.
Note
If your PC with the web browser is connected directly to the stack or
is on the same side of a firewall as the stack, you must configure your
browser’s network options not to use proxies. Consult your web
browser’s documentation on how to configure the switch’s IP
address not to use proxies.
2. Enter the IP address of the stack you want to manage in the URL field
of the browser, as shown in Figure 2.
Figure 2 Entering a Switch’s IP Address in the URL Field
Switch’s IP Address